Welcome

Abstract

An indicator of solid waste generation potential (SWGP) is proposed as a versatile means to assist the development of integrated solid waste (SW) management plans. The proposed indicator is based on key sodoeconomic variables for the State of Illinois which were found to be highly correlated with variables describing the SW stream of the State. The proposed indicator was derived by applying the principal components analysis (PCA) technique. The technique is used to merge the rank transformed socioeconomic variables into a single variable, the SWGP indicator, while maintaining the regional information of the original variables. An innovative aspect of this indicator approach is the use of the ordinal scale for all these diverse variables. The validity of this approach was assessed and the proposed indicator was found to be directly proportional to a composite variable describing the SW stream for the State of Illinois. The use of Geographic Information Systems (GIS) to depict the spatial distribution of the SWGP will help planners visualize the expected overall refuse generation pattern and to identify critical regions. In addition, the proposed indicator could be used as an instrument to validate the solid waste generation (SWG) quantities reported by counties to state agencies.     

ESP Bus Section Failures: Design Considerations

This paper addresses a common operation and maintenance problem encountered with sectionalized electrostatic precipitators—bus section failure. ESPs are normally designed to meet a specific minimum collection efficiency in order to comply with emission standards; the loss of several bus sections may cause the unit to be out of compliance. In this paper, the effect of bus section failure on precipitator performance is analyzed. The study is presented in two parts. First, a simplified procedure to estimate the effect of bus section failure on the overall collection efficiency is developed. An illustrative example is presented to demonstrate the use of the technique. Secondly—and this is the main thrust of this study—the technique is extended to include calculations on whether a unit is out of compliance due to the failure of a given number of bus sections. This development clearly shows that this latter effect can only be expressed in terms of a probability. Two additional examples, based on a field unit using actual test data, complement the presentation and illustrate this probability calculation.     

Application of ultrasonic assisted extraction of chemically diverse organic compounds from soils and sediments

The objective of this research was the development, optimization, and demonstration of an ultrasonic assisted extraction (UAE) based method for organic anthropogenic waste indicators (AWIs) with a range of physicochemical properties from soil and sediment samples. The optimized method was designed to be cost effective compared to existing extraction methods, which may require large quantities of consumables, produce substantial volumes of organic waste, or require costly instrumentation or equipment. Reagent grade sand, soil collected from the native grassland in proximity to Eastern Washington University (EWU), and sediment samples collected from the Spokane river were used as sample matrices during method development. These matrices were fortified with eight AWIs of varying chemical properties that are representative of a variety of household, industrial, and agricultural sources. The recoveries of the AWIs spiked onto these matrices were determined in the extracts using gas chromatography/mass spectrometry (GC/MS). These values reflect the efficiency of the method for extraction of these analytes from representative environmental matrices. Recoveries ranged from 46.1% to 110% in the fortified soil and from 49.2% to 118.6% in the fortified sediment samples, which is comparable with existing methods for the study analytes. The optimized method was then used to quantify AWIs in a biosolid-amended soil. Indole and p-cresol were detected in the biosolid-amended soil.     

Biodegradability and toxicity assessment of trans-chlordane photochemical treatment

The removal of trans-chlordane (C(10)H(6)Cl(8)) from aqueous solutions was studied using UV, UV/H(2)O(2), UV/H(2)O(2)/Fe(2+), UV/TiO(2), or UV/TiO(2)/H(2)O(2) treatment using either UV/Vis blue lamps or UVC lamps (254 nm). H(2)O(2), FeSO(4) and TiO(2) were added at 1700, 456, and 2500 mgL(-1), respectively. trans-Chlordane was not significantly removed in non-irradiated controls and in samples irradiated with UV/Vis. It was also not removed in the absence of surfactant Triton X-114 added at 250 mgL(-1). In the presence of the surfactant, trans-chlordane concentration was reduced by 95-100% after 48 h of UVC and UVC/H(2)O(2) treatments and 70-80% after UVC/H(2)O(2)/Fe(2+), UVC/TiO(2) and UVC/H(2)O(2)/TiO(2) treatments. Based on these results, UVC, UVC/H(2)O(2) and UVC/TiO(2) treatments were further investigated. UVC treatment supported the highest pollutant removal (100% in 48 h), dechlorination efficiency (81% in 48 h), and detoxification to Lepidium sativum seed germination and activated sludge respiration although irradiated samples remained toxic to Chlorella vulgaris. Biodegradation of the UVC irradiated samples removed the source of algae toxicity but this could not be clearly attributed to the removal of trans-chlordane photoproducts because the surfactant interfered with the chemical and biological assays. Evidence was found that trans-chlordane was photodegraded through photolysis causing its successive dechlorination. trans-Chlordane removal was well described by a first order kinetic model at a rate of 0.21±0.01h(-1) at the 95% confidence interval.     

Biodegradability of Quaternized, Crosslinked Sugarcane Bagasse

Quaternized, crosslinked sugarcane bagasse can adsorb anionic dyes from textile wastewater. Disposal of dye-saturated adsorbent by composting or land application would require that modifications made to the bagasse do not interfere with its decomposition. The impact of quaternization and crosslinking on bagasse biodegradability was examined. Bagasse in varying states of modification was mixed with soil and monitored for carbon dioxide evolution for four weeks at 27°C. After subtracting the amount of carbon evolved from control soil samples, the net carbon evolved from the bagasse samples was determined and used as a measure of their extent of biodegradation. Biodegradability decreased in the order: bagasse (approx. 60% degraded after four weeks) > quaternized bagasse > quaternized, epichlorohydrin-crosslinked bagasse > quaternized, methylene-bis-acrylamide-crosslinked bagasse > epichlorohydrin-crosslinked bagasse (less than 5% degraded). Crosslinking severely impacted biodegration, probably by preventing the penetration of (hemi)cellulytic and lignolytic enzymes into the interior of the modified bagasse particles. It is concluded that the biodegradability of quaternized, crosslinked bagasse is too low for composting or land application.     

Comparison of surface emissions and subsurface distribution of cis- and trans-1,3-dichloropropene and chloropicrin in sandy field beds covered with four different plastic films

The purpose of this study was to conduct a field study at a Florida field site on surface emissions and subsurface distribution of cis-and trans-1,3-dichloropropene (1,3-D) and chloropicrin (CP) in raised beds injected with Telone C35 with four replications. A total of 16 beds were applied with Telone C35 by chisel injection and covered with four different plastic films, 4 beds for each film. Each bed was installed with five 20-cm long soil pore air probes and a surface air collection pan at arbitrarily locations along the length of each bed for sampling soil pore air and surface air, respectively, for analysis of the three biologically active compounds, cis- and trans-1,3-D and CP. We found that average concentrations of the three compounds at 20-cm depth among the beds covered with four different plastic films generally were not statistically different. Among the four beds covered with the same plastic film, average concentrations of the three compounds were statistically different only in the four metallic PE covered beds at 5 and 24 hours after injection. Volatilization rates of the three compounds among the beds covered with four different plastic films, with the exception of CP at 48 hours after injection, were not statistically different. It appeared that initial upward diffusion and volatilization flux were influenced by solar radiation. Initial subsurface concentrations of the three compounds and volatilization flux, especially cis-1,3-D, were greater in the beds on the east side of the field than that in the beds on the west side of the field. Whether or not difference in initial subsurface concentrations of the compounds between east side beds and west side beds may influence fumigant efficacy remains to be determined.     

Hydrograph Separation by Incorporating Climatological Factors: Application to Small Experimental Watersheds 1

Abstract: Evaluating the relative amounts of water moving through the different components of the hydrological cycle is required for precise management and planning of water resources. An important aspect of this evaluation is the partitioning of streamflow into surface (quick flow) and base‐flow components. A prior study evaluated 40 different approaches for hydrograph‐partitioning on a field scale watershed in the Coastal Plain of the Southeastern United States and concluded that the Boughton’s method produced the most consistent and accurate results. However, its accuracy depends upon the proper estimation of: (1) the end of surface runoff, and (2) the fraction factor (α) that is function of many physical and hydrologic characteristics of a watershed. Proper identification of the end of surface runoff was accomplished by using a second derivative approach. Applying this approach to 12 years of separately measured surface and subsurface flow data from a field scale watershed (study area) proved to be accurate for 87% of the time. Estimation of the α value was accomplished in this study using two steps: (1) alpha was fitted to individual hydrographs: and, (2) a regression equation that determines these alpha values based on climatological factors (e.g., rainfall, evapotranspiration) was developed. Using these strategies improved the streamflow partitioning method’s performance significantly.     

Policy And Practice Green Grass and Brown Roots: Understanding Environmental Problems in Deprived Neighbourhoods

Understanding neighbourhood conditions can play an important role in urban environmental management, especially when environmental services are lacking and new approachesare being debated. This paper describes and evaluates three research methods for assessing some of the environmentalproblems facing low income households and communities: (1) broad spectrum household surveys; (2) participatory rapid assessment; and (3) contingent valuation. As part of the study upon which this paper is based, the techniques were applied on a small scale in Jakarta. The paper finds that each technique can provide important and often complementaryinsights. The broad spectrum survey is particularly suitable to broad based planning, participatory appraisal to NGO initiatives and contingent valuation to utility pricing decisions.     

Photodegradation of the steroid hormones 17beta-estradiol (E2) and 17alpha-ethinylestradiol (EE2) in dilute aqueous solution

The photochemical transformation of natural estrogenic steroid 17beta-estradiol (E2) and the synthetic oral contraceptive 17alpha-ethinylestradiol (EE2) has been studied in dilute non buffered aqueous solution (pH 5.5-6.0) upon monochromatic (254 nm) and polychromatic (lambda>290 nm) irradiation. Upon irradiation at 254 nm, the quantum yields of E2 and EE2 photolysis were similar and evaluated to be 0.067+/-0.007 and 0.062+/-0.007, respectively. Upon polychromatic excitation, and by using phenol as chemical actinometer, the photolysis efficiencies have been determined to be 0.07+/-0.01 and 0.08+/-0.01 for E2 and EE2, respectively. For both estrogens, photodegradation by-products were identified with GC/MS and LC/MS. In a first step, a model compound--5,6,7,8-tetrahydro-2-naphthol (THN)--, which represents the photoactive phenolic group, was used to obtain basic photoproduct structural informations. Numerous primary and secondary products were observed, corresponding to hydroxylated phenolic- or quinone-type compounds.